Simulink Control Design™ - MathWorks

Command-Line Information Parameter: SnapshotTimes Type: character vector Value: 0 | positive real number | vector of positive re ...

Enable zero-crossing detection Enable zero-crossing detection to ensure that the software computes the linear system characteris ...

On Compute linear system characteristics at the exact snapshot time or exact time when a trigger signal is detected. This settin ...

Command-Line Information Parameter: UseExactDelayModel Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot L ...

Positive finite value. Use to compute: A discrete-time linear system from a continuous-time system. A discrete-time linear syst ...

Tustin (bilinear) Bilinear (Tustin) approximation without frequency prewarping. The software rounds off fractional time delays t ...

enables Prewarp frequency (rad/s) on page 16-259. Command-Line Information Parameter: RateConversionMethod Type: character vecto ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

Value: 'on' | 'off' Default: 'off' See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verif ...

Command-Line Information Parameter: UseBusSignalLabels Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot L ...

Tips Clearing this parameter disables the settling time bounds and the software stops checking that the bounds are satisfied du ...

Settings Default: [] for Pole-Zero Plot block 1 for Check Pole-Zero Characteristics block Finite positive real scalar for one b ...

This parameter is used for assertion only if Enable assertion on page 16-277 in the Assertion tab is selected. You can specify m ...

If you specify other bounds, such as settling time on page 16-262, damping ratio on page 16-268 or natural frequency on page 16 ...

Settings Default: [] for Pole-Zero Plot block 10 for Check Pole-Zero Characteristics block Minimum: 0 Maximum: 100 Real scalar ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

If you specify other bounds, such as settling time on page 16-262, percent overshoot on page 16-264 or natural frequency on pag ...

Settings Default: [] Minimum: 0 Maximum: 1 Finite positive real scalar for single damping ratio bound. Cell array of finite pos ...

Include natural frequency bound in assertion Check that the pole locations satisfy approximate second-order bounds on the natura ...

If you also specify settling time on page 16-262, percent overshoot on page 16-264 or damping ratio on page 16-268 bounds and w ...