Simulink Control Design™ - MathWorks

Rising edge Rising edge of the external trigger signal. Falling edge Falling edge of the external trigger signal. Dependencies S ...

As shown in the following figure, when zero-crossing detection is enabled, the variable-step Simulink solver simulates the model ...

“Verify Model at Default Simulation Snapshot Time” on page 14-6 Use exact delays How to represent time delays in your linear mod ...

Resample a discrete-time system with a different sample time Compute a continuous-time system from a discrete-time system When ...

Sample time rate conversion method Method for converting the sample time of single-rate or multirate models. This parameter is u ...

You can upsample only when you convert a discrete-time system to a new faster sample time that is an integer multiple of the sam ...

Dependencies Selecting either Tustin with Prewarping Upsampling when possible, Tustin with Prewarping otherwise in Sample time ...

On Show state and input/output names with their path through the model hierarchy. For example, in the chemical reactor model, a ...

Bus signal names appear when the input and output are at the output of the following blocks: Root-level inport block containing ...

This parameter is used for assertion only if Enable assertion on page 16-173 in the Assertion tab is selected. The bounds also a ...

Tips Clearing this parameter disables the step response bounds and the software stops checking that the bounds are satisfied du ...

Command-Line Information Parameter: FinalValue Type: character vector Value: [] | 1 | finite real scalar. Must be specified insi ...

Default: '[]' for Linear Step Response Plot block, '5' for Check Linear Step Response Characteristics block. See Also Plot Linea ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

% Settling The percentage of the final value that defines the settling range of the Settling time on page 16-166. Settings Defau ...

% Overshoot The amount by which the step response can exceed the final value, specified as a percentage. Settings Default: Minim ...

% Undershoot The amount by which the step response can undershoot the initial value, specified as a percentage. Settings Default ...

The saved data is in a structure whose fields include: time — Simulation times at which the linear systems are computed. values ...

Command-Line Information Parameter: SaveToWorkspace Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot Line ...

Command-Line Information Parameter: SaveName Type: character vector Value: sys | any character vector. Must be specified inside ...